MG TF 1.8 PRT Silicone Radiator Coolant & Breather Hose Kit

Note: Some types of coolant are not compatible with silicone hoses. Please click here to download our Important Fitting Notes before buying and fitting silicone hoses.

This high quality reinforced silicone hose kit replaces 23 coolant hoses including the front radiator hoses, heater hoses and other minor coolant hoses at the front of the car and in the engine bay. The hoses are a direct fit for the Pressure Relief Thermostat (PRT) model which was fitted to late '03 onwards vehicles as standard (VIN number 3D614000 onwards).

Due to some differences in the heater hose connectors the hoses cannot be used to fit a PRT to earlier models, but we have a new kit coming soon for earlier models with a PRT retrofitted.

The hoses will also fit 160 / VVC models but the kit does not include the two additional VVC hoses for the oil cooler which are available as a separate kit.

Hose Clamps:

The kit is available with a full set of hose clamps using the options above. The three types of clamp we offer are shown below, but not all options will appear for some kits due to size limitations:

Spring clamps are the most commonly used type by vehicle manufacturers. They provide excellent evenly distributed clamping force and are generally the best option for clamping coolant hoses, but they can be fiddly to fit/remove, and being mild steel they are more prone to surface rust over time. Whilst this won't affect the performance or lifespan of the clamp some customers prefer our stainless steel options below which tend to look better and still perform as they should.

Worm-Drive clamps have slightly less evenly distributed clamping force as the Spring type clamps, but they are still a good quality clamp and usually easier to fit/remove in the tight confines of an engine bay. Being 100% stainless steel they do not rust, so we recommend this type of clamp if you are concerned about the appearance of your engine bay.

T-Bolt clamps * Not available for this product *

For some vehicles the original clamps can be reused so we also offer our kits without clamps, but please be aware our silicone hoses are slightly thicker than the standard hoses so in some cases the original clamps may be too small.

Specification:

• Application: MG TF Chassis (from VIN 3D614000) '03-'05 | 1.8 K-Series Engines with PRT Only | Manual Transmissions Only
• Construction: ~4.5mm 4-ply silicone with 3-ply polyester reinforcing
• Max Operating Pressure: >7bar
• Burst Pressure: >10bar
• Operating Temperature range: -50°c to 180°c
• Warranty: 3 Years (UK based)